Supply voltage is 1h110V
Since the control unit will be installed in the house, the necessary cable length of 60 m. Using the table are defined and cross-section of the cable. At the chosen Taco pump power is 0,7-1,05 kW, therefore, cable with a length of 60 m shall be 2.5 mm2. To connect the cable with the cable selected pump will need to purchase additional sleeve type KM 3 (1,5-2,5).
Among other advantages, borehole pumps are fairly simple and easy to install and operate. First, you need to clean the well, water otkachivaya special pump to pump assemblies until the well has been completely cleared of sand and other inclusions. This procedure should be drilling organization. Then, you must delete the new Taco pump in the well with ropes, securing the rope through the terminals at the top of the well. After this set start device and the setting of .. If the Taco pump is not integrated check valve, install it immediately after the Taco pump to avoid the “movement” of water back. Then adjust the pressure in the pressure tank, it should be 0.9 on the pressure off. Then you can run the Taco pump, making sure that the incoming water was clean. Of course, it is better to entrust all of these actions specialist – in fact bona fide organization not only correctly pick up and install the Taco pump, but also take it to warranty service.
Life outside the city now – it’s not only an opportunity to escape from the stifling metropolis and rest in the bosom of nature. It is also quite decent comfort, which provides modern technology. However, like all complex devices and equipment, it requires certain knowledge and skills, which, however, available to everyone. The task of this article – to introduce the methodology of selection of such important devices as Taco pump to make the country staying comfortable and enjoyable.