pex tubing plumbing
Installation of butt joints of PEX tubing OxyPEX for plumbing.
* Make a mark on the envelope at a distance x, (y) from the end of the pipe.
* Cut saw shell.
* Cut the shell in the longitudinal direction.
* Insert the knife at a depth of 5 mm.
* Separate the shell.
* Remove isolated by the length of x, (y).
* Cut at a right angle pipe PEX. Blunted.
* Set the clamping lugs.
* Perform a bond pipeline.
* The cut ends of the insulation waterproofing layer on the length of 50mm.
* Wear of the PEX shell on the joint so that the edge of the casing formed butt with a shell on the exposed ends of the insulating layer of the pipeline. Pull hood tie straps and fasten it with screws, 50 mm in the zone of overlap.
* The casing to drill a hole d = 20 mm, into a clean container necessary in terms of the joint embedding of components A and B (in proportions according to the technological instructions of supplier firms), mix the components of a drill with a special paddle-stirrer and pour through a hole in the joint mixture components of the foam.
* Plug the drainage hole stopper.
* Upon completion of the foaming component foam and harden, remove the drain plug, remove the tie straps. Then waterproof the junction of heat-shrinkable tape using a gas burner.